| 0661-467 |
| Mechanical data |
Dimensions |
| Height |
1.62
in. 41.275 mm |
| Width |
4.00 in.
101.6 mm |
| Depth* |
5.75 in.
146.0 mm |
| Weight |
2.2 lbs 1.0 kilograms |
|
*The connectors exceed the depth dimension by 6.37 mm. |
Clearances |
A minimum of 2 mm clearance should be
given to the top and bottom surfaces (except at the bottom mounting
holes.)
To assist cooling, it is recommended
that a clearance of 6 mm be provided above and below the drive.
Precautions must be taken to avoid
blocking any of the vent holes (on the side and ends of the drive). |
Mounting |
The drive can be mounted in any of the
following positions: |
| |
- Bottom side down
- Right side down
- Left side down
- Back end down
|
There are 4 mounting holes on the
bottom, and two on each side of the drive. (See diagram below for
locations).
The torque applied to the mounting
screws must not exceed 1.0+ and -0.1 Newton meters. |
 |
| Side View |
 |
| Bottom View
Note: Maximum screw lenghts
must not be exceeded. |
|
|
