Note: The SCSI ID setting is to be set via the C3 connector (not by C4) normally. In case the SCSI ID setting is done by remote switch via the C4 connector and remote cable, remove all Jumper Sockets from the C3 connector to avoid SCSI ID control conflicts.
68-pin power connector
Note: The DC power
connectors used on 68 and 80 pin SCA-2 models are an integral
portion of the 68 pin SCSI 'Unitized' Connectors and 80 pin 'Single
Connector Attachment' (SCA-2) connector.
