|
Outline Dimensions and Mounting Holes
- The recommended mounting screw torque is 0.6 - 1.0 Nm (6 - 10 kgcm).
- Maximum allowable penetration of the left and right side mounting screws on the drive is 4.5 mm.
- Maximum allowable penetration of the bottom mounting screws on the drive is 4.0 mm.
Front Dimensions
Rear Dimensions (detailed)
Mounting Holes
Connectors
This example is typical of most current Deskstar drives. However, dimensions may vary slightly from model to model.
For model-specific information, review the drive specifications for your
Deskstar drive.
Mounting a Deskstar Hard Disk Drive
There are many variations of system cases. A Deskstar drive can be
mounted by any side or end, vertical or horizontal. Do not mount the
drive in a tilted position.
Steps for Mounting
- Place the drive in an empty drive bay and line up the four screw holes.
Make sure to use all four screws when mounting the drive, as a loose drive
may vibrate when in use and result in drive failure. Consult your system
manual for additional information.
- Check all internal cable connections to ensure they are securely seated.
- Replace the system cover.
- Check all external cable connections to ensure they are securely seated.
- Plug in your computer.
|
