Deskstar 60GXP
Jumper settings |
Models: IC35L060AVER07, IC35L040AVER07, IC35L030AVER07, IC35L020AVER07, IC35L010AVER07 |
Jumper
block location · Jumper
settings · Capacity
Clip 2GB/32GB · Disabling
auto spin · Notes |
|
Jumper
block location
 |
[Top] |
|
Jumper settings
Jumpers may be fitted to select the following options:
Note: Some systems may require you to use the 15 head logical
architecture. This is because they translate a drive greater than 4 GB by multiplying the head count by
16. The result (16 x 16 = 256) is interpreted as 0 heads with a 0 capacity and is an illegal head
count. Selecting the 15 head logical jumpers produces a legal translation (16 x 15 = 240). The
translated cylinder count varies to achieve the drive's full capacity. |
Capacity
clip to 2GB/32GB with logical head 16
This
option can be used in situations where there is a
BIOS limitation and the drive is not recognized.
The following jumper
settings forces the values of Word 1, 3, 6 and 60-61
in Identify Device data as follows:
|
| IC35L060AVER07, IC35L040AVER07
(factory default capacities > 32 GB) |
| Word
1/3/6 (C/H/S): |
Remain
ship default value |
| Word
60/61 (LBA) |
66055248 |
Note:
Installing the 2GB/32GB capacity clip jumpers
for a 34GB and higher drive reduces the drive
capacity to 33.8GB.
|
| IC35L030AVER07, IC35L020AVER07, IC35L010AVER07
(factory default capacities < 32 GB) |
| Word
1/3/6 (C/H/S) |
4096/16/63 |
| Word
60-61 (LBA) |
Remain
ship default value |
Note:
Installing the 2GB/32GB capacity clip jumpers
for a drive with a capacity of less than 34GB
reduces the drive capacity to 2GB.
|
[Top] |
|
Notes:
|
- 16 head logical architecture is enabled as the
shipping default. Master is set to on (i.e.
jumper on pins A-B and G-H). No other jumpers
are fitted.
- Auto Spin Disable, disables the drive from
automatically spinning up when power is applied.
- The clip capacity 2GB/32GB option clips the
capacity of the disk drive down to 2 GB for
drives with a capacity of less than 34GB and
clips the capacity down to 33.8GB for drives
with a capacity of more than 34GB. For example,
a 10.1GB drive with this option set will appear
as a 2GB drive and a 40GB drive with this option
set will appear as a 33.8GB drive.
- When CABLE SELECT is specified, AT interface
signal #28 CSEL determines the drive
address
as follows:
- When CSEL is grounded or at a low level, the
drive address is 0 (Device0).
- When CSEL is open or at a high level, the
drive address is 1 (Device1).
|
[Top] |
|
|
|
|
|
