Travelstar LP
Electrical interface specifications |
Models: DBOA-2360, 2528, 2540, 2720 |
| |
| IDE signal connector |
 |
| Notes:
|
- Pin position 20 is blank.
- Pin position 47 through 50 are used for drive address setting.
|
| |
| Signal definition |
The pin assignments of interface signals are listed as follows: |
| |
PIN Signal I/O PIN Signal I/O
01 -HRESET I 02 GND
03 HD07 I/O 04 HD08 I/O
05 HD06 I/O 06 HD09 I/O
07 HD05 I/O 08 HD10 I/O
09 HD04 I/O 10 HD11 I/O
11 HD03 I/O 12 HD12 I/O
13 HD02 I/O 14 HD13 I/O
15 HD01 I/O 16 HD14 I/O
17 HD00 I/O 18 HD15 I/O
19 GND (20) Key
21 DMARQ 22 GND
23 -HIOW I 24 GND
25 -HIOR I 26 GND
27 IORDY O 28 CSEL I
29 DMACK 30 GND
31 HIRQ O 32 -HIOCS16 O
33 HA01 I 34 -PDIAG I/O
35 HA00 I 36 HA02 I
37 -HCSO I 38 -HCS1 I
39 -DASP I/O 40 GND
41 +5V Logic PWR 42 +5V Motor PWR
43 GND 44 (Resv)
|
| Notes: |
"O" designates an output from the drive.
"I" designates an input to the drive.
"I/O" designates an input/output common.
"PWR" designates a power supply to the drive.
"(Resv)" designates reserved pins which must be left unconnected. |
| |
| +5 volt power supply |
|
|
There are two input pins for +5 V power supply, "+5V logic" and
"+5V motor". "+5V logic" is connected to the internal logic
circuits and "+5V motor" is connected to the spindle motor and motor
driver.
It is possible to turn on and off "+5V logic" by an external switch
circuit to reduce power consumption to the least possible. In this mode, a
voltage drop out due to the motor spin up current can be reduced by connecting
"+5V motor" line into the system power source directly.
|
| |
|
