|
Travelstar DHAS (SCSI)
Jumper settings
Models: DHAS-2270, DHAS-2405 and DHAS-2540
| The drive recognizes its device address, namely SCSI ID, with the condition
of -ID1, -ID2 and -ID4. The signal condition and the device address are shown
below. |
 |
| 40 pin SCSI Connector
|
J2 pins - SCSI address setting |
| -ID1 (pin 5) |
-ID2 (pin 6) |
-ID4 (pin 7) |
Device address |
| Open |
Open |
Open |
0 |
| Ground |
Open |
Open |
1 |
| Open |
Ground |
Open |
2 |
| Ground |
Ground |
Open |
3 |
| Open |
Open |
Ground |
4 |
| Ground |
Open |
Ground |
5 |
| Open |
Ground |
Ground |
6 |
| Ground |
Ground |
Ground |
7 |
| |
| Signal termination
|
The drive does not have termination or pull up resistors on the SCSI
interface bus. |
| |
|
