Models: DHEA-36480 and DHEA-34330

DC power connector

The DC power connector is designed to mate with AMP part 1-480424 (using AMP pins P/N 350078-4). Equivalent assignments are shown below, viewed from the end of the drive.

IDE connector

The drive uses single-ended drivers and receivers. The connector is designed to mate with 3M part 3417-7000 or equivalent.

Notes:

1. A/T = IDE
2. It is intended that the drive should only be in electrical contact with the chassis of a designated set of mounting holes. Other electrical contact may degrade error rate performance. As a result of this it is recommended that there should be no metal contact to the drive except at the mounting holes or the side rails into which the mounting holes are taped.