skip header   hitachi.com   hitachi.us    Global
Hitachi Global Storage Technologies
 
Deskstar 25GP and 22GXP
Electrical interface specifications

Deskstar 25GP models: DJNA-352500, 352030, 351520, 351010
Deskstar 22GXP models: DJNA-372200, 371800, 371350, 370910

Connectors

The DC power connector is designed to mate with AMP part 1-480424 (using AMP pins P/N 350078-4). Equivalent connectors may be used. Pin assignments are shown below, viewed from the end of the drive.

DC power connector

A/T (IDE) interface connector

The drive uses single-ended drivers and receivers. The connector is designed to mate with 3M part 3417-7000 or equivalent.

IDE connector

Cabling

The maximum cable length from the host system to the drive, plus the circuit pattern length inside the host systems, must not exceed 18 inches (45.7 cm).  For systems operating with Ultra DMA mode 3 or 4, the 80-conductor ATA cable assembly (SFF-8049) should be used.

Pin assignments

Pin Signal I/O Pin Signal I/O
01 -RESET I 02 GND
03 DD07 I/O 04 DD08 I/O
05 DD06 I/O 06 DD09 I/O
07 DD05 I/O 08 DD10 I/O
09 DD04 I/O 10 DD11 I/O
11 DD03 I/O 12 DD12 I/O
13 DD02 I/O 14 DD13 I/O
15 DD01 I/O 16 DD14 I/O
17 DD00 I/O 18 DD15 I/O
19 GND (20) KEY
21 DMARQ O 22 GND
23 -DIOW* I 24 GND
25 -DIOR* I 26 GND
27 IORDY* O 28 CSEL I
29 -DMACK I 30 GND
31 INTRQ O 32 -HIOCS16 O
33 DA01 I 34 -PDIAG/-CBLID I/O
35 DA00 I 36 DA02 I
37 -CSO I 38 -CS1 I
39 -DASP I/O 40 GND

Notes:

  1. "O" designates an output from the drive.
  2. "I" designates an input from the drive.
  3. "I/O" designates an input/output common.
  4. The signal lines marked with (*) are redifined during the Ultra DMA protocol to provide special functions as detailed in the table below.

 

Operation Ultra DMA Conventional definition
Write Operation -DDMARDY IORDY
HSTROBE -DIOR
STOP -DIOW
Read Operation -HDMARDY -DIOR
DSTROBE IORDY
STOP -DIOW






  Terms of Use | Privacy Policy | Contact Us  © 2008 Hitachi Global Storage Technologies