skip header   hitachi.com   hitachi.us    Global
Hitachi Global Storage Technologies
 

DK312C Jumper Plug Installation
The following jumpers are accessible to the user.
Jumper Pin No.
SCSI ID setting jumper JP114
J6		 9-14
1-6
SCSI bus parity jumper JP114 15-16
Terminator power on/off JP121 1-4
WRITE PROTECT setting jumper J6 9-10
MOTOR START/STOP setting jumper JP114 3-4
Look ahead cache function setting jumper JP114 1-2
Look ahead cache function segment setting jumper JP126 1-6
SCSI ID POLARITY INVERTED setting jumper J6 7-8
Note 1)
The DK312C jumpers other than listed above (Black Jumper) are installed by the manufacturer and must not be replaced by the user.
Never remove any of the "BLACK" factory set jumpers.
These jumpers are unique to each drive.
All jumpers should be set with power off.

Jumper Plug Location

Fig. 2.2 Jumper Plug Installtion

Note 1)
: Jumper installed : User changeable
Note 2)
The terminator (TM117) of the DK312C other than the last drive of SCSI Daisy Chain must be removed.
 


Contact Support  

Downloads  

Hitachi Design Studios  

Technical Library  

Warranty/RMA  
  Terms of Use | Privacy Policy | Contact Us  © 2008 Hitachi Global Storage Technologies