DK31AH-36LC/DK32AH-18(-91)LC Jumper socket installation
Wide LVD 68pin-16bits
| Option Jumper Connector C3 |
*Indicates Default Settings |
| Pin |
Function |
Removed |
Installed |
| 1-2 |
ID3(8) |
* |
|
| 3-4 |
ID2(4) |
* |
|
| 5-6 |
ID1(2) |
* |
|
| 7-8 |
ID0(1) |
* |
|
| 11-12 |
Reserved |
|
|
| 13-14 |
Force SE bus mode |
Single-ended
or LVD mode* |
Only Single-ended mode |
| 15-16 |
Reserved |
|
|
| 17-18 |
LED |
|
|
| 19-20 |
Write Protect |
Write Enable* |
Write Disable |
| 21-22 |
Delayed Spindle Start |
At Power on *
(Note1) |
In 10 sec X ID intervals after power on
(Note1) |
| 23-24 |
Reserved |
|
|
| 25-26 |
Reserved |
|
|
| 27-28 |
Reserved |
|
|
| 29-30 |
Force CMD start |
Refer Note2 as follows * |
Only by SCSI command |
| 31-32 |
Reserved |
|
|
Pin 17:LED sink
Pin 18:LED source
ID 0-15 selectable by configuring pins 1-8. |
|
| Note1:This jumper is valid when C1 38&78pins
and C3 29-30 are OPEN. |
Note2:Motor start is set as follows.
-C1 38p is GND:Only by SCSI cmd.
-C1 38&78p are Open:same as Note1.
-C1 38p is Open and 78p is GND:SCSI ID X 10sec intervals
|
-
|
|
|
