|
DK328H-43/DK318H-91 Jumper socket installation
Narrow single ended Type
The following jumpers are accessible to the user.
- Note 1)
- The DK328H/DK318H jumpers other than listed above (Black Jumper) are installed by the manufacturer and must not be replaced by the user.
- Never remove any of the "BLACK" factory set jumpers.
- These jumpers are unique to each drive.
- All jumpers should be set with power off.
Jumper Connector Layout (Narrow single ended Type)
|
Pin No. |
1-2 |
3-4 |
5-6 |
7-8 |
9-10 |
| Connector No. |
|
| JP2 |
Delayed Spindle Start |
Write Protect |
Factory Setting |
Factory Setting |
Factory Setting |
| JP3 |
Term. Power from Drive |
Term. Power from SCSI Bus |
Enable Terminator |
Disable Spindle Auto Start |
Disable SCSI Bus Parity |
| J6 |
ID 0 |
ID 1 |
ID 2 |
Reserved |
9:LED(sink)
10:LED(source) |
- Note 1
- Green jumper sockets are used for the customer's selection.(They are shown with thick lines)
- Shaded Jumper sockets are default setting at the factory.
- Jumper sockets JP2-5,6,7,8,9,10 are used at the factory with Black Jumper sockets. Installing or removing these black jumpers will void any warranties of the HDD.
|
|
|
