DK328H-43/DK318H-91 Jumper socket installation
SCA (Single Connector Attachment) Wide single ended Type
The following jumpers are accessible to the user.
- Note 1)
- The DK328H/DK318H jumpers other than listed above (Black Jumper)
are installed by the manufacturer and must not be replaced by
the user.
- Never remove any of the "BLACK" factory set jumpers.
- These jumpers are unique to each drive.
- All jumpers should be set with power off.
Jumper Connector Layout (SCA Wide single ended Type)
|
Pin No. |
1-2 |
3-4 |
5-6 |
7-8 |
9-10 |
| Connector No. |
|
| JP2 |
Factory Setting |
Write Protect |
Factory Setting |
Factory Setting |
Factory Setting |
| JP3 |
Not Used |
(Reserved) |
Not Used |
Factory Setting |
Disable SCSI Bus Parity |
| J6 |
Reserved |
Reserved |
Reserved |
Reserved |
9:NC
10:NC |
- Note 1
-
- Green jumper sockets are used for the customer's selection.(They
are shown with thick lines)
- Shaded Jumper sockets are default setting at the factory.
- Jumper sockets JP2-1,2,5,6,7,8,9,10 are used at the factory
with Black Jumper sockets. Installing or removing these black
jumpers will void any warranties of the HDD.
- In the case of SCA WIDE (16-bit) single-ended model, all
of the jumper sockets for J6 connector are removed as a default
so that the SCSI ID setting can be done by a command from
host via the J1 connector.
|
|
|
