DK514C Jumper Plug Installation
- Jumper Plug Installation (PCB Rev. A/D1 or former)
The following jumpers are accessible to the user (use green jumper
plugs) :
- Note 1)
- The DK514C jumpers other than listed above are installed by
the manufacturer and must not be replaced by the user (black
jumper plugs).
- Note 2)
- The JP261 located near the JP257 is used as for Motor Start/Stop
jumper in the P/B Rev. 0 and 1 PC board.
The JP261 is replaced by JP257 (Pin 3-4) in the P/B Rev. 2 or
more board.
JUMPER SOCKET LAYOUT
Fig. 2-7a SZ916 PCB Jumper Locations (at the shipment).
- Note:
-
| *1) |
The terminator of the DK514C other than the last drive
of SCSI Daisy Chain must be removed. |
-
| *2) |
 :Jumper installed
 :User changeable
(Green Jumper)
* Other than them are inhibited to change |
-
-
-
-
-
-
|
|
|
