The following jumpers are accessible to the user (use green jumper plugs) :

Note 1)

The DK514C jumpers other than listed above are installed by the manufacturer and must not be replaced by the user (black jumper plugs).

Note 2)

The JP261 located near the JP257 is used as for Motor Start/Stop jumper in the P/B Rev. 0 and 1 PC board.
The JP261 is replaced by JP257 (Pin 3-4) in the P/B Rev. 2 or more board.

Fig. 2-7 SZ916 PCB Jumper Locations (at the shipment).

Note:

*1)	The terminator of the DK514C other than the last drive of SCSI Daisy Chain must be removed.

*2)	:Jumper installed :User changeable (Green Jumper) * Other than them are inhibited to change