1. For DK514S-38S,set by JP174 (pin 1-8) or JP179 (pin 1-8) on the SZ906 PCB.
SZ906 PCB Rev.0 Jumper Location
SZ906 PCB Rev.1 Jumper Location

Drive No.	0	1	2	3
PCB Rev.0 JP174 (pin 1-8) or PCB Rev.1 JP179 (pin1-8)
	4	5	6	7
	8	9	10	11
	12	13	14	15

Fig. 2-7A Jumper setting for Drive address selection of DK514S-38S (SZ906)

Notes:

1. If drive address numbers 8-15 are used, Modes A or B must be selected.
2. As shipped, drive is set to drive address number 0.

2. For DK514S-38D, set by JP85(pin 1-8) on the SZ241 PCB.
SZ906 PCB Rev.0 Jumper Location
SZ906 PCB Rev.1 Jumper Location

Drive No.	0	1	2
JP85 (pin 1-8)
	3	4	5
	6	7	8
	9	10	11
	12	13	14
	15

Fig. 2-7B Jumper setting for Drive address selection of DK514S-38D (SZ241)

Notes:

1. If drive address numbers 8-15 are used, Modes A or B must be selected.
2. As shipped, drive is set to drive address number 0.