These 2 additional SCSI ID connectors are mounted on /pcb Rev. 4-. (P/K Rev. A/M4-)

(A) J7-pin 5~8 (External connector)

(B) J8-pin 1~10 (Jumper plugs/External connector)

1) Pin Assignment

(A) J7-Pin 5~8

pin#	Signal Name
5	GND
6	SCSI ID 2^0
7	SCSI ID 2^2
8	SCSI ID 2^1

Note 1:

When this connector is used for SCSI ID setting.
ID 20,21,22 signal at other connector/Jumper (ie : JP248-Bit20~22, J8-Pin 6,8,10).
shall be opened.

(B) J8-Pin 1~10

pin#	Signal Name	pin#	Signal Name
1	GND	2	ID Polarity
3	GND	4	ID Polarity
5	GND	6	SCSI ID 2^2
7	GND	8	SCSI ID 2^1
9	GND	10	SCSI ID 2^3

2Pin and 4Pin of J8 are common on PCB.

a) Both 2Pin and 4Pin are opened,

ID 2^n = 1  When each pin is opened.
       = 0                is shorted.

b) At least, one of 2Pin and 4Pin is shorted,

ID 2^n = 0  When each pin is opened.
       = 1                is shorted.

Note 1:

When this connector is used for SCSI ID setting.
ID 20,21,22 signal at other connector/Jumper (ie:JP248-Bit 20~21, J7-Pin 6~8) shall be opened.

Note 2:

When ID Polarity signal is shorted, the polarity of ID 2n will be reversed, whichever the ID connector is used from J7,J8 and JP248.
But the signals other than ID2n (ie, Parity, Motor Start/Stop, Write Protect, etc.) are not influenced by this signal.

Table 2-5 External SCSI ID Control Jumper/Connector

Configuration	J8-Pin 2,4		JP248 Bit2^0-2^2	J8-Pin 6,8,10	J7-Pin 5~8
Old P/B Rev 0~2	Normal	Not Support	Normal	Not Support	Not Support
New P/B Rev.4			Shown as below	Shown as below	Shown as below (at customer side)
SCSI ID#	0	7
	1	6
	2	5
	3	4
	4	3
	5	2
	6	1
	7	0
Notice at setting (Only one connector can be used Others should be opened)			J8-Pin6,8,10 and J7-Pin 5~8 should be opened	JP248-20~22 and J7-Pin 5~8 should be opened	JP248-20~22 and J8-Pin6,8,10 should be opened
Setting tool	Jumper socket		Green Socket (with the JP248)	Blue Socket (with J8)	Can not connect
	Cable Connector (Recommended)		Can not connect	BERG #65043-34	BERG #65043-35

2) Connector (Male) and Recommended User connector (Female)

XX :32(10 Pin)
   :33(8 Pin)
   :34(6 Pin)

*1:

The jumper plugs for J8 are colored with Blue, and can be connected with square Pin of J8.
The Blue color is used to distinguish it from Green colored jumper socket which can not connect with square Pin but with rounded pin.
So, please don't use Green colored jumper socket with J8.

3) Dimension

*1:

J8 is 5.08mm longer than standard formfactor 203mm