DK515C Jumper Plug Installation
Synchronized spindle jumper (JP223 Bits 2^1-2^2)
The Synchronized spindle option can be supported by the combination
of these jumpers. At the time of shipment, these jumpers are set
at "Off Line Mode", which means non-supported. The mode
to be supported will be decided when power is turned on.
The mode can be certified by MODE SENSE command and changed by MODE
SELECT command.
Table 2-4 Synchronized Spindle option
JP223
(Bit 2^1-2^2) |
 |
 |
 |
|
| Mode |
Off line |
Slave |
Master |
Reserved |
The cable array is shown as below.
- Note 1:
- Terminator Jumper (JP266) must be removed from drives except
those located at both cable end.
Fig. 2-8-1 Cable for Synchronized Spindle Signals
|
