skip header   hitachi.com   hitachi.us    Global
Hitachi Global Storage Technologies
 
DK516C Jumper Plug Installation
Before this Jumper Plug Installation/setting, please use ESD protected cushioning material for safer operation.
The following jumpers are accessible to the user (use green jumper plugs, as for J8 use blue jumper plugs) :
Jumper Bit
SCSI ID setting jumper J8 2^0-2^2
SCSI bus parity jumper J8 2^3
Terminator power on/off jumper JP5 2^0-2^1
Write protect jumper JP4 2^0
Motor Auto-start option jumper JP2 2^0
Synchronized spindle jumper
Synchronized spindle Terminator
Synchronized spindle signal connector		 JP3
JP7
J7		 2^0-2^1

Pin1-4
Note 1)
The DK516C jumpers other than listed above are installed by the manufacturer (black jumper plugs) and must not be replaced by the user.

Fig. 2-7 Jumper Location (at the shipment)

Note:
*1) The terminator of the controller other than the last drive of SCSI Daisy Chain must be removed.
*2) The terminator for Synchronized Spindle option.
*3) : Jumper at the shipment : User changeable (Green Jumper)
*4) Connector for J8
 
 


Contact Support  

Downloads  

Hitachi Design Studios  

Technical Library  

Warranty/RMA  
  Terms of Use | Privacy Policy | Contact Us  © 2008 Hitachi Global Storage Technologies