Travelstar 3LP
Product description
Models: DMCA-21080 and DMCA-21440
Features
- Magneto resistive head
- No-ID sector formatting
- PIO data transfer - mode 4
- DMA data transfer
Single word mode - mode 2
Multiword mode - mode 2
- Enhanced ECC on the fly
- S.M.A.R.T. function
Configuration
Interface IDE
Formated capacity 1080/1440 MB
Sector size 512 Bytes
Sectors/track (logical) 63
Head number (logical) 16
Cylinder number (logical) 2100/2800
Customer usable data sectors 2,116,800/2,822,400
Disks 2
Recording zones 8
Areal density average (max) 1.29 Gb/sq.in.
Recording density (Kbpi)(max) 150.5
Track density 8600 TPI
Performance
Rotational speed 4000 RPM
Media transfer rate 61.8 (OD)/39.5 (ID) Mb/sec
Data buffer 96 KB
Interface transfer rate (max) 16.6 MB/sec
Latency average 7.5 msec
Seek time (typical)
Average (read) 13 msec
Track to track 4 msec
Full track (read) 23.0 msec
Spin up (typical) 2.3 sec
Power
Requirements +5 volts
Power supply ripple (0-20) max 100 mV p-p *1
Tolerance +(-)5% *2
Dissipation (typical)
Idle 0.85 Watts 0.17 A RMS *3
Read/Write 2.3 Watts 0.46 A RMS
Seek 2.3 Watts 0.46 A RMS *4
Standby 0.3 Watts 0.06 A RMS
Sleep 0.1 Watts 0.02 A RMS
Start up (maximum peak) 4.7 Watts 0.94 A RMS *5
Start up (average to ready) 3.5 Watts 0.70 A RMS *6
Supply rise time 7 - 100 msec
Physical size
Height 12.5 mm
Width 70 mm
Depth 100 mm
Weight (max) 140 g
Environmental characteristics
Altitude
Operating -300 to 3000 m
Ship / store -300 to 12000 m
Temperature
Operating 5 to 55 C
Storage 0 to 65 C
Shipping -40 to 65 C
Temperature gradient (max) 15 C / hour
(Operating, storage or shipping)
Operating
Ambient temperature 5 to 55 C
Relative humidity (non-condensing) 8% to 90%
Maximum wet bulb (non-condensing) 29.4 C
Shock (half-sine wave) 100 G/2 msec
Vibration random (RMS) 0.67 G (5-500 Hz)
Non-Operating
Ambient temperature 0 to 65 C
Relative humidity (non-condensing) 5% to 95%
Maximum wet bulb (non-condensing) 40 C
Shock (half-sine wave) 500 G/2 msec
Vibration random (RMS) 1.04 G (2-200 Hz)
Notes:
- The maximum supply ripple is measured at the 5 V input on
the drive.
- The drive shall not incur damage for an over voltage
condition of +25% (maximum duration of 20ms) on the 5 V
nominal supply.
- The idle current is specified at inner track.
- The read/write current is specified based on three
operations of 63 sector read/write per 100 ms.
- The seek average current is specified based on three
operations per 100 ms
- The worst case operating current includes motor surge.
|