The following information is the only information available for these drives:

Jumper settings

Positions 3 and 4 are used to park un-used jumpers. 

Note: When a drive 1 (slave) is installed in the system with a drive 0 (master) already installed, there is no change to the jumper setting for a drive 0 (master). Only the jumper of drive 1 (slave), bit 2, is required to be removed. The jumper may be stored for later use by moving it to bit 3 which is unused.

Bit No.      Name           Description
-------      -------                -------------------------------------
  1          IORDY              If a host supports IORDY signal, this bit
                                      must be set ON.
  2         -DRV0/DRV1      When set ON, the drive is set as drive 0 (master)
                                      When set OFF, the drive is set as drive 1 (slave)
  3            --                     Not available
  4            --                     Not available

Data organization

Disks                1
Heads               2
RPM            3600
Tracks          2134
Sec/trk             39
Cylinders       1067